Cisco Cisco 1 GHz GainMaker Amplifier Guía De Instalación
Chapter 2 Installation and Configuration
30
bottom align with the pin holes in the equalizer slot, allowing the equalizer to
install flat against the line extender module.
install flat against the line extender module.
The same inverse equalizer is used for either 870 MHz, 1 GHz and 1.2GHz.
The locations for equalizers are approximately the same for all GainMaker
Line Extender. The illustration above shows a typical example.
Line Extender. The illustration above shows a typical example.
The forward interstage equalizer is installed at the factory, and should not be
changed in the field. While it is a 1.2 GHz equalizer, it is appropriate for use
in both 1.2 GHz, 1GHz and 870 MHz system applications.
changed in the field. While it is a 1.2 GHz equalizer, it is appropriate for use
in both 1.2 GHz, 1GHz and 870 MHz system applications.
The plug-in interstage equalizer and an on-board interstage equalizer
combine to produce the total internal tilt for the station. The plug-in
interstage equalizer value is different from one type of line extender to
another by design, in order to achieve optimum performance.
combine to produce the total internal tilt for the station. The plug-in
interstage equalizer value is different from one type of line extender to
another by design, in order to achieve optimum performance.
3 Install the reverse equalizer specified by the design print in the reverse equalizer
slot. For the exact location of the reverse equalizer, refer to the accompanying
illustration. For a list of available reverse equalizers, see datasheet.
illustration. For a list of available reverse equalizers, see datasheet.
4 Install other options or accessories as desired, or proceed to Installing the Line
Extender Module (on page 33).
To Install the Crowbar Surge Protector
Complete the following steps to install the crowbar surge protector in the line
extender.
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
extender.
1 Begin this procedure with the housing open. Refer to To Open the Line Extender
Housing (on page 15).
2 Remove the line extender cover by loosening the line extender cover screws.