Cisco Cisco Content Security Management Appliance M390 Guía Del Usuario
14-40
AsyncOS 9.5.x for Cisco Content Security Management Appliances User Guide
Chapter 14 Common Administrative Tasks
Configuring the System Time
Step 3
Submit and commit your changes.
Configuring the Default Gateway
You can configure the default gateway via the GUI through the Management Appliance > Network >
Routing page (see
Routing page (see
) or via the
setgateway
command
in the CLI.
Configuring the System Time
Note
When gathering data for reports, the Security Management appliance applies the time stamp from the
information that was set when you configured the time settings on the Security Management appliance.
For information, see
information that was set when you configured the time settings on the Security Management appliance.
For information, see
To set time-related settings using the command-line interface, use the
ntpconfig
,
settime
, and
settz
commands.
Using a Network Time Protocol (NTP) Server
You can use a Network Time Protocol (NTP) server to synchronize the Security Management appliance
system clock with other computers on your network or the internet.
system clock with other computers on your network or the internet.
The default NTP server is
time.sco.cisco.com
.
If you will use an external NTP server, including the default NTP server, open the required port through
the firewall. See
the firewall. See
To
Do This
Set the system time
Select Management Appliance > System
Administration > Time Settings
Administration > Time Settings
See also
Set the time zone
Select Management Appliance > System
Administration > Time Zone
Administration > Time Zone
See also:
•
•