Cisco Cisco WAP351 Wireless-N Dual Radio Access Point with 5-Port Switch Manual De Mantenimiento
Client Quality of Service
ACL
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
123
7
•
Source MAC Address—Select this field and enter the source MAC address
to compare against an Ethernet frame.
to compare against an Ethernet frame.
•
Source MAC Mask—Select this field and enter the source MAC address
mask specifying which bits in the source MAC to compare against an
Ethernet frame.
mask specifying which bits in the source MAC to compare against an
Ethernet frame.
For each bit position in the MAC mask, a 0 indicates that the corresponding
address bit is significant and a 1 indicates that the address bit is ignored. For
example, to check only the first four octets of a MAC address, a MAC mask
of 00:00:00:00:ff:ff is used. A MAC mask of 00:00:00:00:00:00 checks all
address bits and is used to match a single MAC address.
address bit is significant and a 1 indicates that the address bit is ignored. For
example, to check only the first four octets of a MAC address, a MAC mask
of 00:00:00:00:ff:ff is used. A MAC mask of 00:00:00:00:00:00 checks all
address bits and is used to match a single MAC address.
•
Destination MAC Address—Select this field and enter the destination MAC
address to compare against an Ethernet frame.
address to compare against an Ethernet frame.
•
Destination MAC Mask—Enter the destination MAC address mask to
specify which bits in the destination MAC to compare against an Ethernet
frame.
specify which bits in the destination MAC to compare against an Ethernet
frame.
For each bit position in the MAC mask, a 0 indicates that the corresponding
address bit is significant and a 1 indicates that the address bit is ignored. For
example, to check only the first four octets of a MAC address, a MAC mask
of 00:00:00:00:ff:ff is used. A MAC mask of 00:00:00:00:00:00 checks all
address bits and is used to match a single MAC address.
address bit is significant and a 1 indicates that the address bit is ignored. For
example, to check only the first four octets of a MAC address, a MAC mask
of 00:00:00:00:ff:ff is used. A MAC mask of 00:00:00:00:00:00 checks all
address bits and is used to match a single MAC address.
•
VLAN ID—Select this field and enter the specific VLAN ID to compare
against an Ethernet frame.
against an Ethernet frame.
This field is located in the first/only 802.1Q VLAN tag.
STEP 5
Click Save. The changes are saved to the Startup Configuration.
NOTE
To delete an ACL, ensure that it is selected in the ACL Name-ACL Type list, select
Delete ACL, and click Save.
Delete ACL, and click Save.