Cisco Cisco FirePOWER Appliance 8270 Notas de publicación
Version 5.3.0.6
Sourcefire 3D System Release Notes
6
Updating Your Appliances
Updating Your Appliances
To update appliances running at least Version 5.3 of the Sourcefire 3D System to
Version 5.3.0.6, see the procedures outlined below. The following sections help
you to prepare for and install the Version 5.3.0.6 update:
•
•
WARNING!
Do not reboot or shut down your appliances during the update until
you see the login prompt. The system may appear inactive during the pre-checks
portion of the update; this is expected behavior and does not require you to
reboot or shut down your appliances.
Planning the Update
Before you begin the update, you must thoroughly read and understand these
release notes, especially
on page 3. To ensure a smooth update process, you must also read the
following sections.
Sourcefire 3D System Version Requirements
To update to Version 5.3.0.6, an appliance must be running at least Version 5.3. If
you are running an earlier version, you can obtain updates from the
Note that although this release does not contain an update for Defense Centers,
Sourcefire strongly recommends that you use them to update the devices they
manage. A Defense Center must be running at least Version 5.3.1 to update its
managed devices to Version 5.3.0.6.
The closer your appliances’ current version to the release versions (Version
The closer your appliances’ current version to the release versions (Version
5.3.0.6), the less time the update takes.
Operating System Requirements
You can host 64-bit virtual Sourcefire virtual devices on the following hosting
environments:
•
VMware vSphere Hypervisor/VMware ESXi 5.0
•
VMware vSphere Hypervisor/VMware ESXi 5.1
•
VMware vCloud Director 5.1
For more information, see the Sourcefire 3D System Virtual Installation Guide.
You can run Sourcefire Software for X-Series on the X-Series platform running
You can run Sourcefire Software for X-Series on the X-Series platform running
XOS Version 9.7.2 and later and Version 10.0 and later. For more information, see
the Sourcefire Software for X-Series Installation and Configuration Guide.