Cisco Cisco FirePOWER Appliance 8390
9-8
FireSIGHT System User Guide
Chapter 9 Setting Up Virtual Routers
Configuring Virtual Routers
Step 6
For
Type
, select
SFRP
to display the SFRP options.
Step 7
In the
Group ID
field, enter a value that designates a group of master or backup interfaces configured for
SFRP.
Step 8
For
Priority
, select either
Master
or
Backup
to designate the preferred interface:
•
For individual devices, you must set one interface to master on one device and the other to backup
on a second device.
on a second device.
•
For device clusters, when you set one interface as master, the other automatically becomes the
backup.
backup.
Step 9
In the
Shared Secret
field, type a shared secret.
The Shared Secret field populates automatically for a group in a device cluster.
Step 10
In the
Adv. Interval (seconds)
field, enter an interval for route advertisements for Layer 3 traffic.
Step 11
Click
OK
.
The IP address is added or edited.
Step 12
Click
Save
.
Your changes are saved. Note that your changes do not take effect until you apply the device
configuration; see
configuration; see
.
Configuring Virtual Routers
License:
Control
Supported Devices:
Series 3
Before you can use routed interfaces in a Layer 3 deployment, you must configure virtual routers and
assign routed interfaces to them. A virtual router is a group of routed interfaces that route Layer 3 traffic.
assign routed interfaces to them. A virtual router is a group of routed interfaces that route Layer 3 traffic.
See the following sections for more information about configuring virtual routers:
•
•
•
•
Viewing Virtual Routers
License:
Control
Supported Devices:
Series 3
The Virtual Routers tab of the Device Management page
(Devices > Device Management > Virtual Routers)
displays a list of all the virtual routers you have configured on a device. The table includes summary
information about each router, as described in the following table.
information about each router, as described in the following table.