Samsung SWT65D2 Manual De Usuario

HOW TO CLEAN THE FILTER 
(In case drain pump)
1. Place a rag under the washer filter 

not to wet the floor.

2. Rotate the filter counterclockwise 

and pull out the filter.

3. Remove dirts and 

rotate the filter 
clockwise until it 
locks in position.

When you open this
lid while the spin basket is
spinning,the spinning will 
be stopped by the brake
system.

(without pump)

The plug’s shape 
may not be similar to that
shown in this drawing.

(with pump)

Be sure to keep 

the lid closed 

during washing 

and spinning.

This is used for

gathering the 

dregs made during 

washing.

• 

Pull the overflow filter out and take up 

the filter by removing  3 screws as 
shown in figure. Wash the filter and 
washing tub.

• 

Push the strainer(filter) out and take

up the filter as shown in figure.
Wash the filter and washing tub.

DRAIN FILTER
In case of incomplete drain,
disassemble the drain filter with 
screw driver(+), and remove 
lints from the filter as shown 
in the filter as shown in 
the figure.

CLEANING THE WASH TUB
First, fill water in the wash tub to ‘L’ level(

, then drain water from the wash tub simultaneously with 

operating wash cycle for 1~2 minutes. 

•

2

• 

Pull the upper side of the 

overflow filter with your
fingers into the holes 
in the direction of 
arrow as shown

in the figure.

• 

If the dregs are piled up in the    

lint filter after finishing the wash,
push down and 
pull it out as 
shown in the
figure.

• 

Wash the filter 

net in water.

OVERFLOW FILTER
Pull the upper side of the 
overflow filter with 
two fingers inserted into
hole ‘A’ in the 
direction of arrow   
as shown in the figure.

A