Samsung SWT65D2 Manual De Usuario
1 After rinsing you can select this
course for more effective rinse
(Don't just select this course
for rinse.) Load the laundry
evenly into the spin basket.
(Don't just select this course
for rinse.) Load the laundry
evenly into the spin basket.
2 Set the WATER SELECTOR
KNOB to SPIN and
CYCLE SELECTOR
KNOB to ‘DRAIN’.
CYCLE SELECTOR
KNOB to ‘DRAIN’.
3 Supply water for about 1 minute.
Adjust the water flow to prevent
overflow from the wash tub.
overflow from the wash tub.
4 After completing the water supply,
cover the laundry with
safety cover and close
the inner lid.
safety cover and close
the inner lid.
5 Close the spin dryer lid.
6 Set the SPIN DRY
TIMER 2~3 minutes.
Leave some space of
at least 15cm between the washing machine
and the wall.
and the wall.
Place the washing machine on a sturdy flat
surface.
surface.
If the washer is placed on an uneven or weak
surface, noise or vibration may be occured.
(Allowable is 2˚)
surface, noise or vibration may be occured.
(Allowable is 2˚)
Never install the washing machine near water.
Do not place the washing machine in steamy rooms
or where the washing machine is directly exposed
to rain. Moisture may damage electrical insulation
and cause an electrical shock to occur.
or where the washing machine is directly exposed
to rain. Moisture may damage electrical insulation
and cause an electrical shock to occur.
Avoid direct sunlight or heating devices.
As plastic and electrical components are affected
by direct heat, never place the washing machine
near heaters, boilers, etc., or under direct sunlight.
by direct heat, never place the washing machine
near heaters, boilers, etc., or under direct sunlight.
Install the drain hose
about 70~80cm above
the ground for pump model.
about 70~80cm above
the ground for pump model.
MOUNTING THE LEGS
Lay down the washer with its back facing
downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
Insert the claw of the
leg with the square
hole of the leg
mounting section,
and push the leg in
the arrow direction
as shown in the
figure until it clicks.
downward. Insert four legs into the leg mounting
sections of the base corners of the main body.
Insert the claw of the
leg with the square
hole of the leg
mounting section,
and push the leg in
the arrow direction
as shown in the
figure until it clicks.
Before attempting to change the position of the
drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole
drain hose, disconnect the plug from the outlet.
1. Route the drain hose inside the machine.
2.Take out the drain hose from the opposite hole
and insert the drain hose into the hose holder.
CONNECTING THE DRAIN HOSE
After attaching the connector ring(a), insert
the drain hose(b) in the draining direction.
CONNECTING THE DRAIN HOSE
1. Before connecting the drain hose, remove
the cover (a) from the drain hole.
2. After pressing the joint ring (b), insert the
drain hose(c) to drain direction.
WATER SELECTOR
Wash
Spin
70~80cm
Claw
Square
hole
Bottom face of
main body
Leg
1
2
inner lid
safety
cover
cover
0
3
1
4
2
5
SPIN DRY TIMER
INSTALLATION
ADDITIONAL RINSE
LOCATION
CHANGING THE POSITION
OF THE DRAIN HOSE
OF THE DRAIN HOSE
4
a
b
(In case of pump
drained washer)
drained washer)
(C)
(b)
(C)
(b)
(a)
2
1
Hose holder