Samsung External Dispenser French Door With FlexZone Drawer Guía De Instalación Rápida

setting up

_07

SETTING

AccESSORIES AND REquIRED
TOOLS

The following accessories are included with your
refigerator:

Hex wrench

Fastener

compression

fitting

compression

nut

Required Tools (Not provided)

You need the following tools to complete the
installation of your refirgerator:

Philips screwdriver (+)

Flat-blade screwdriver

(-)

Socket wrench

(10mm)

Pliers

Allen wrench (3/16”) (5mm)

REMOVING THE REFRIGERATOR
DOORS

Some installations require door removal to transport
the refrigerator to its final location.
Do not remove the door/drawer if you don't need to.
If you do not need to remove the refrigerator doors, go
to Adjusting the Level on page 8.
If you need to remove the doors. continue below.
Before removing the door/drawer, make sure you read
the following items:

Disconnect power to the refrigerator before
removing the door or drawer.

• Be careful not to drop, damage or scratch

the door/drawer while removing them.

• Be careful not to get injured while removing the

door/drawer.

• Reattach the door/drawer properly to avoid:

- Moisture from air leakage.

- Uneven door alignment.

- Wasting energy due to improper door seal.

Disassemble the refrigerator doors

Be careful not to drop and scratch the doors
while removing the doors.

Disassemble the refrigerator doors

1. With the door opened, remove the cap top table

(

1 ) with a flat-blade screwdriver (-), and close the

door.
Remove the 3 screws holding down the top table
(

2 ) and turn it with several wires connected.

2. Disconnect one connector ( 3 ) on the right side

door and one connector (

4 ) on the left side door.

Remove the water line (

5 ) while pressing the dark

gray color part (

6 ) of the water line coupler.

If a red clip is on the coupler, it must be
removed before removing the tube.

WARNING

cAuTION

WARNING

Red clip

(1/4")

DA68-02520A(0.0)-EN.indd 7

2011.3.2 8:38:32 AM