Samsung SNC-L200N Manual De Usuario

This is where to configure whether using this Service or not.
Selecting “Enable” will allow you to use “Alarm Notification” function.

It means Simple Mail Transfer Protocol (SMTF) Server address.
This address is used to transfer E-mails.
Enter the after @ part of the Email Address you use.

It is recommended to select “Enable.”

When using the Authentication Login, enter User ID and User
Password of the sender’s Email Address. They are usually
designated at the time the mail service is subscribed.

Enter the sender’s Email Address.
Do not use a bogus name because the mail server often check it to
block Spam mails.

Up to 4 Email Addresses can be registered to receive video data.

Up to 5 images can be sent with a 0.5-second interval each. The
number of image count will be shown.

Assuming the sender’s Email Address is “inyoung.heo@samsung.com,” and the Password
is “1234567,” the “Alarm Notification” should be configured as follows.

Perform general network configuration. If network configuration is not done properly, you
cannot to transfer images via Internet Explorer or configure Netcam on the web. Please
ask your network administrator and enter the following setup information correctly. To
apply the settings to Netcam, you must click “Apply” button.

This is the menu to set “Static IP” or “DHCP.”

This is the menu to set PPPoE (ADSL).

This is the menu to set “HTTP Port.“

This is the menu to view current system network status.

This is the menu used to notify the information of IP Address
that is dynamically allocated, such as DHCP or PPPoE.

This is the menu used to set DDNS.