3com WX4400 3CRWX440095A Manual De Usuario
MAP Overview
183
MAP Parameters
Table 9 summarizes parameters that apply to individual MAPs, including
dual-homing parameters. (For information about parameters for
individual radios, see “Configuring a Radio Profile” on page 240 and
“Configuring Radio-Specific Parameters” on page 246.)
dual-homing parameters. (For information about parameters for
individual radios, see “Configuring a Radio Profile” on page 240 and
“Configuring Radio-Specific Parameters” on page 246.)
Table 9 Global MAP Parameters
Parameter
Default value
Description
name
Based on the port or
Distributed MAP connection
number. For example:
Distributed MAP connection
number. For example:
MAP01
DAP01
MAP name.
bias
high
Setting a MAP’s bias on a
WX switch to high causes the
switch to be preferred over
switches with low bias, for
booting and managing the
MAP.
WX switch to high causes the
switch to be preferred over
switches with low bias, for
booting and managing the
MAP.
Note: Bias applies only to
WX
switches that are
indirectly attached to the
MAP through an
intermediate Layer 2 or Layer
3 network. A MAP always
attempts to boot on MAP
port 1 first, and if a WX
switch is directly attached on
MAP port 1, the MAP boots
from it regardless of the bias
settings.
MAP through an
intermediate Layer 2 or Layer
3 network. A MAP always
attempts to boot on MAP
port 1 first, and if a WX
switch is directly attached on
MAP port 1, the MAP boots
from it regardless of the bias
settings.
group
None
Named set of MAPs. MSS
load-balances user sessions
among the access points in
the group.
load-balances user sessions
among the access points in
the group.
upgrade-firmware
enable
Automatic upgrade of boot
firmware.
firmware.
blink
disable
LED blink mode — blinking
11a LED (AP2750) or health
and radio LEDs (MAP-xxx)
make the MAP visually easy
to identify.
11a LED (AP2750) or health
and radio LEDs (MAP-xxx)
make the MAP visually easy
to identify.