HP dl385 Manual De Usuario

 

Operations 23 

To remove the component: 

1. 

Power down the server if performing a non-hot-plug installation or maintenance procedure ("

2. 

Extend the server from the rack (on page 

3. 

Use the T-15 Torx screwdriver attached to the rear of the server to loosen the security screw on the 
hood latch. 

4. 

Lift up on the hood latch handle and remove the access panel. 

 

Install the access panel 

1. 

Place the access panel on top of the server with the hood latch open. Allow the panel to extend past 
the rear of the server approximately 1.25 cm (0.5 in). 

2. 

Push down on the hood latch. The access panel slides to a closed position. 

3. 

Use the T-15 Torx screwdriver attached to the rear of the server to tighten the security screw on the 
hood latch. 

 

Remove the air baffle 

  

 

IMPORTANT:

  To maintain proper airflow and prevent thermal damage, always install the air 

baffle. 

  

1. 

Power down the server (on page 

2. 

Extend or remove the server from the rack ("

" on page 

3. 

Remove the access panel (on page 

). 

  

 

CAUTION:

  Disconnecting the battery module cable will cause any unsaved data in the cache 

module to be lost. 

  

4. 

Disconnect the cable, and then remove the BBWC battery pack.