HP proliant ml370 Manual De Usuario

Removal and replacement procedures  29 

Power down the server 

  WARNING:  To reduce the risk of personal injury, electric shock, or damage to the 

equipment, remove the power cord to remove power from the server. The front panel 
Power On/Standby button does not completely shut off system power. Portions of the 
power supply and some internal circuitry remain active until AC power is removed. 

  IMPORTANT:  If installing a hot-plug device, it is not necessary to power down the server. 

Shut down the OS as directed by the OS documentation. 

Press the Power On/Standby button to place the server in standby mode. When the server enters 
standby power mode, the system power LED changes to amber.  

Disconnect the power cords. 

The system is now without power. 

 

Extend the server from the rack 

  IMPORTANT:  If the server is installed in a telco rack, remove the server from the rack to access internal 

components. 

Extend the server on the rack rails until the server rail-release latches engage. 

  WARNING:  To reduce the risk of personal injury or equipment damage, be sure that the 

rack is adequately stabilized before extending a component from the rack. 

  WARNING:  To reduce the risk of personal injury, be careful when pressing the server 

rail-release latches and sliding the server into the rack. The sliding rails could pinch your 
fingers. 

After performing the installation or maintenance procedure, slide the server into the rack by pressing 
the server rail-release latches. 

 

 

Remove the server from the rack 

To remove the server from an HP, telco, or third-party rack: 

Power down the server (on page 

Disconnect the cabling.