HP procurve 2500 Manual De Usuario

239    

The startup-config file saved under version F.05.05, or later, is NOT backward-compatible with 
previous software versions.  The user is advised to save a copy of the pre-05.05 startup-config file 
BEFORE UPGRADING to F.05.05 or greater, in case there is ever a need to revert back to pre- 05.05 
software.  Instructions for saving a copy of the startup-config file are found in the "Transferring Switch 
Configurations" section of Appendix A in the Management and Configuration Guide (included on 
the Product Documentation CD-ROM (PDF format)) that shipped with the switch. 

■

Agent processes (such as console, telnet, STP, ping, etc.) may stop func-

tioning when the IGMP querier function is disabled, and then re-enabled, on a VLAN that 
does not have an IP address configured.

■

Changing the IP address of a VLAN does not delete the ARP entry for the old IP 

address.

■

Garp event log messages may be garbled.

■

The CLI command 

show arp displays the wrong port number for some ARP entries.

■

The CLI command 

show trunks lists incorrect information for dynamic trunks.

■

The CLI command 

getmib with no parameters returns the message Incomplete 

input: - EOI -

.

■

Unrelated information was shown at the end of the CLI command "show vlan 1" 

output.

■

Command "no qos" did not reset port priority to "0".

■

When reaching the inactivity timeout expiration after typing the CLI command 

"enable" in a telnet session at operator mode, the text in the CLI prompt may get corrupted 
with text similar to "gfs_alp_104Null Varbind".

■

The CLI command "show tech" causes an error message when the command is 

executed from within config mode.

■

The prompt for saving the config does not handle a DISC character appropriately.

■

The switch time is wrong if CLI used to set timezone and timezone may 

not operate properly after switch is rebooted. West of GMT is now a negative offset and east 
of GMT is now a positive offset.