HP ProLiant ML330 G6 Manual De Usuario
Hardware options installation 62
10.
Connect the tape drive cable to the rear of the drive and to the SAS controller.
11.
Remove the applicable bezel blanks from the bezel ("
12.
13.
Do one of the following:
o
Close or install the tower bezel, as needed.
o
Slide the server back into the rack.
14.
Power up the server (on page
Expansion board options
The server supports PCI Express and PCI-X expansion boards. Slot 1 is located on the optional PCI-X
extender board.
Slot Expansion
card type
Connector Maximum
speed
1
PCI-X (optional)
64 bit, 3.3 V
100 MHz
2
PCI-X (optional)
64 bit, 3.3 V
100 MHz
3 PCIe
x8
x1
4 PCIe
x16
x16
5 PCIe
x8
x4
6 PCIe
x8
x4
Removing the expansion slot cover
1.
Power down the server (on page
).
2.
Do one of the following:
o
Open or remove the tower bezel, as needed ("
o
Extend the server from the rack (on page