HP qms 1660e Manual De Usuario
Single In-Line
Memory
Modules
6-29
Printer Options
M
WARNING!
Turn off the printer and unplug the power cord before
taking the cover off the printer.
ACHTUNG!
Bitte schalten Sie den Drucker aus und ziehen Sie den
Netzstecker heraus bevor Sie die Druckerabdeckung öffnen.
▲
Caution:
It's very important to protect the printer controller board and
SIMMs from electrostatic damage while performing this task. Review
the anti-static guidelines in the “Removing the Printer and Controller
Board Covers” section, earlier in this chapter. Handle SIMMs
carefully, preferably only by the edges.
the anti-static guidelines in the “Removing the Printer and Controller
Board Covers” section, earlier in this chapter. Handle SIMMs
carefully, preferably only by the edges.
Remove a SIMM as follows:
1
Access the printer controller board.
Use the instructions in the “Removing the Printer and Controller
Board Covers” section of this chapter.
Board Covers” section of this chapter.
2
Position the controller board so the interface panel is on your
right.
right.
3
Release the
SIMM.
SIMM.
Pull the latch on
each side of the
SIMM connector
outward using your
thumbs.
each side of the
SIMM connector
outward using your
thumbs.
4
Remove the
SIMM.
SIMM.
Tilt the SIMM
backward to a 45°
angle away from
the SIMM connec-
tor, and then lift it
out.
backward to a 45°
angle away from
the SIMM connec-
tor, and then lift it
out.
45°
Latches