Sony 4-168-043-14(1) Manual De Usuario

 

 

 

 

 

 

 

x SW LEVEL

Lets you set the level of the subwoofer to 0 dB 
or +10 dB when multi channel Linear PCM 
signals are input via an HDMI connection. You 
can set the level for each HDMI input 
independently.
• SW AUTO 

Automatically sets the level to 0 dB or 

 

+10 dB depending on the frequency. 

• SW +10 dB
• SW 0 dB

This parameter is only available when HDMI input 
signals are detected.

x SW L.P.F.

Lets you set the low pass filter of the 
subwoofer when multi channel Linear PCM 
signals are input via an HDMI connection. Set 
the “SW L.P.F.” if your connected 
subwoofer’s crossover frequency do not have 
low pass filter.
• L.P.F. ON

The low pass filter of the subwoofer’s cut off 
frequency is set to 120 Hz.

• L.P.F. OFF

The low pass filter of the subwoofer is 
turned off.

This parameter is only available when HDMI input 
signals are detected.

x ARC

Lets you enjoy the TV sound from the 
speakers connected to the receiver via an 
HDMI cable. For details, see “Enjoying the 
TV sound via an HDMI cable” (page 51).
• ARC ON

Audio signal is input to the HDMI TV OUT 
jack.

• ARC OFF

Audio signal is output through the TV 
OPTICAL IN jack or TV AUDIO IN jack.

This parameter is not available when 
“CTRL.HDMI” is set to “CTRL OFF”.

You can customize the settings of the receiver.

x DIMMER

Lets you adjust the brightness of the display in 
3 levels.

x SLEEP

Lets you set the Sleep Timer on the receiver to 
turn off automatically at the specific time. For 
details, see “Using the Sleep Timer” (page 37).

x AUTO.STBY

Lets you set the receiver switch to standby 
mode automatically after 30 minutes when 
you do not operate the receiver or when there 
is no signals input to the receiver.
• STBY ON

Switches to standby mode after 
approximately 30 minutes.

• STBY OFF

Does not switch to standby mode.

• This function does not work when TUNER input is 

selected. 

• If you use the auto standby mode and the Sleep 

Timer at the same time, the Sleep Timer has 
priority.

x NAME IN 

Lets you set the name of inputs. For details, 
see “Naming inputs” (page 36).