Sony DH280 Manual De Usuario

Ot
her

s

Assigning the IP Address to the Camera Using ARP Commands

121

This section explains how to assign an IP address to the 
camera using ARP (Address Resolution Protocol) 
commands without using the SNC toolbox.

When you turn on the camera, execute the ARP and 
PING commands within 5 minutes. Also when you 
restart the camera, execute the operation within 
5 minutes.

Open the command prompt on the computer.
When using Windows Vista, right click Command 
prompt in Start-All Programs- Accessories, and 
select Run as administrator.

Enter the IP address and the MAC address of the 
camera to assign a new IP address, using the 
following ARP commands.

Example:

When the following line is displayed on the 
command prompt, hold down Ctrl and press C.
Display stops.

You will normally receive a reply after about 5 
repetitions of “Request time out”.

Wait until the execution of PING finishes, then 
input the following code.

If you do not receive a reply, check the following:
– Did you enter the ARP commands within 5 minutes 

after it was turned on?
If not, turn off the camera and restart the operation.

– Is a NETWORK indicator turned on?

If the indicator goes off, the network connection has a 
problem. Connect the network correctly.

– Did you enter the IP address previously used for 

another device?
Assign a new IP address to the camera.

– Do the computer and the camera have the same 

network address?
If not, set the same network address on the computer 
and the camera.

arp -s <Camera’s IP address> <Camera’s MAC address>
ping -t <Camera’s IP address>

arp -s 192.168.0.100 08-00-46-21-00-00
ping -t 192.168.0.100

Reply from 192.168.0.100:bytes=32 time...

arp -d 192.168.0.100