Sony SNC-CH110 Manual De Usuario

A

d

mini

s

tra

ting
 t

he 

Came

ra

Configuring the System — System Menu

37

You can configure the output setting for the monitor 
output terminal of this unit. Select On to output an 
NTSC or PAL signal.

• Monitor out is used when you install this unit to 

adjust the angle of view, etc. Be sure to set Off and 
unplug the AV cable when you do not use this 
function.

• Be aware that the system performance may be 

influenced, if monitor out is set to on.

• The output signal format is determined according to 

the setting of the camera’s NTSC/PAL switch.

• Motion detection function is not available when 

Monitor out is set to On.

Used when rebooting the camera.
Click Reboot, and the message “This System will be 
rebooted. Are you sure?” appears. Click OK to reboot 
the camera. It takes about two minutes to restart.

Resets the camera to the factory settings.

Retain current network settings
When this item is checked, only the current network 
settings will be retained after reset.
Click Factory default, and the message “Setup data will 
be initialized. Are you sure?” appears. 
When you click OK, the network indicator on the 
camera starts to blink. After adjustments of the default 
settings have finished, the camera reboots automatically. 
Do not turn off the camera until the camera reboots.

The camera can also be reset to the factory settings by 
turning on the power of the camera while pressing the 
reset button on the camera. For details, see the supplied 
Installation Manual.

Saves the setting data of the camera in a file.
Click Save, and follow the instructions on the Web 
browser to specify the folder and save the setting data of 
the camera. 
The file name preset at the factory is “snc-ch210.cfg” for 
SNC-CH210.

Loads the stored setting data of the camera.
Click Browse and select the file in which the setting data 
is stored. Click OK, and the camera is adjusted 
according to the loaded data, and restarted.

Restore preset position
If you select this, the stored setting data of the camera 
and the preset position data are loaded.

• With Restore setting, some items in the Network 

menu (page 44) cannot be restored.

• When Restore preset position is selected, it may take 

some time to load the setting data.

• The following items cannot be stored or restored with 

Backup setting data or Restore setting.
– a homepage created using Custom Homepage of 

SNC toolbox

– a client certificate and CA certificate to be used in 

the 802.1X authentication function

– Header logo
– superimpose logo

Click Delete to delete the homepages recorded in the 
flash memory of the camera with Custom Homepage of 
SNC toolbox (page 84).

When you click Capture, a full image covering the 
entire shooting range is shot and saved to the camera. 
The full image is captured regardless of the image size 
and crop settings.

Main viewer image may be interrupted or image and/or 
audio files may not be created correctly during image 
capturing.