Panasonic kx-tg7214e Manual De Usuario
Preparation
13
Helpline Tel. No.: U.K. 0844 844 3898 R.O.I. 01289 8333
When the batteries are fully charged,
“Charge Completed” will be
displayed.
“Charge Completed” will be
displayed.
*1 The pictured model is KX-TG7210.
*2 KX-TG7212/KX-TG7213/
*2 KX-TG7212/KX-TG7213/
KX-TG7214/KX-TG7232/
KX-TG7233/KX-TG7234
KX-TG7233/KX-TG7234
Note:
L
L
It is normal for the handset to feel
warm during charging.
warm during charging.
L
If you want to use the unit
immediately, charge the batteries for
at least 15 minutes.
immediately, charge the batteries for
at least 15 minutes.
L
Clean the charge contacts of the
handset, base unit, and charger with a
soft, dry cloth once a month. Clean
more often if the unit is subject to the
exposure of grease, dust, or high
humidity.
handset, base unit, and charger with a
soft, dry cloth once a month. Clean
more often if the unit is subject to the
exposure of grease, dust, or high
humidity.
Battery level
Panasonic Ni-MH battery
performance (supplied batteries)
performance (supplied batteries)
Note:
L
L
It is normal for batteries not to reach
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
full capacity at the initial charge.
Maximum battery performance is
reached after a few complete cycles of
charge/discharge (use).
L
Actual battery performance depends
on a combination of how often the
handset is in use and how often it is
not in use (standby).
on a combination of how often the
handset is in use and how often it is
not in use (standby).
L
Even after the handset is fully
charged, the handset can be left on
the base unit or charger without any ill
effect on the batteries.
charged, the handset can be left on
the base unit or charger without any ill
effect on the batteries.
L
The battery level may not be
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and let it charge for at least 7 hours.
displayed correctly after you replace
the batteries. In this case, place the
handset on the base unit or charger
and let it charge for at least 7 hours.
Turning the power
on/off
on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Base unit
Charger
Battery icon
Battery level
5
High
6
Medium
7
Low
L
L
When flashing:
Needs to be
charged.
Needs to be
charged.
Operation
Operating
time
time
In continuous use
15 hours max.
In continuous
standby mode
standby mode
160 hours
max.
max.
TG7210-7230E(e).book Page 13 Tuesday, October 16, 2007 12:59 PM