Gateway E-9722R Manual De Usuario
CHAPTER 4: Installing Components
50
8
Loosen the two thumbscrews (1) that secure the system board to the server.
9
Slide the system board toward the back of the server until it is free of the five retaining
standoffs (2), then lift the board from the chassis.
standoffs (2), then lift the board from the chassis.
10
Place the old system board in a static-free bag for storage.
11
Insert the new system board into the chassis, aligned with the eight retaining standoffs,
then slide the board toward the front of the case so the board is held by the standoffs.
then slide the board toward the front of the case so the board is held by the standoffs.
12
Tighten the two system board thumbscrews you loosened in
.
13
Connect the cables you removed in
14
Replace the heatsink(s) and processor(s) Follow the instructions in
15
16
17
Reinstall the PCI riser assembly by following the instructions in
.
18
.
19
Restart your server, then press F2 at any time after you see the LEDs on your keyboard
flash or turn off. The BIOS Setup utility opens.
flash or turn off. The BIOS Setup utility opens.
20
Check BIOS settings to make sure that they detect the server’s new hardware, then save
your changes (if any) and close the BIOS Setup utility.
your changes (if any) and close the BIOS Setup utility.
21
If your server does not start after installing the new system board, contact Gateway
Customer Care. For more information, see
Customer Care. For more information, see
2
2
2
2
1
2
1