Gateway 7250R Manual De Usuario
Replacing the power supply
51
8
Replace the expansion slot cover bracket and tighten the thumbscrew.
9
Replace the card guide by sliding it back to its original position until it
clicks in place. Make sure the end of the card is in the right slot in the
card guide.
clicks in place. Make sure the end of the card is in the right slot in the
card guide.
10
Connect any cables to the card (see card documentation for proper cable
orientation).
orientation).
11
Close the case. (See “Closing the case” on page 20.)
12
Reconnect the peripherals and the power cord, then turn on the system.
You may need to reconfigure the server after installing some expansion cards.
You may also need to install software that came with the card. Check the card
documentation for additional information.
You may also need to install software that came with the card. Check the card
documentation for additional information.
Replacing the power supply
The 275-W power supply provides all system power through a power
distribution board.
distribution board.
To replace the power supply:
1
Turn off the system and disconnect the power cord and all peripherals.
2
Open the case. (See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.)
electricity discharge” on page 17.)
8506162.book Page 51 Wednesday, May 10, 2000 10:21 AM