Gateway 7250R Manual De Usuario
92
Troubleshooting
The diskette drive LED illuminates continuously
The system does not recognize an expansion card
Printer problems
The printer will not turn on
The diskette is corrupted
Run CheckDisk on the diskette. If errors are detected and
corrected, try accessing the diskette again.
corrected, try accessing the diskette again.
Probable cause
Solution
The diskette is corrupted
Remove the diskette from the drive. If the light remains on,
try restarting the system.
try restarting the system.
The cable to the drive is
not connected properly
not connected properly
Open the system, then make sure the cable between the
diskette drive and its controller is properly connected. Make
sure that the pins are not bent or misaligned.
diskette drive and its controller is properly connected. Make
sure that the pins are not bent or misaligned.
Probable cause
Solution
The interrupt or I/O
address is set incorrectly
address is set incorrectly
Check the address configuration of the adapter card and
make sure that it does not conflict with another card in the
system.
make sure that it does not conflict with another card in the
system.
The card has not been
configured through the
software
configured through the
software
Configure the card with the appropriate software.
The card was not installed
correctly
correctly
Make sure the card jumpers are set correctly and reseat
the card.
the card.
Probable cause
Solution
The printer is not onlne
(ready)
(ready)
Make sure the on-line or ready light is on, or the display
indicates “Ready.”
indicates “Ready.”
The printer is not turned
on
on
Make sure that the power switch is depressed or set to the
On position. If power is applied to the printer, the green
power LED should be illuminated.
On position. If power is applied to the printer, the green
power LED should be illuminated.
Probable cause
Solution
8506162.book Page 92 Wednesday, May 10, 2000 10:21 AM