Escalade Sports 2l-6433-00 Manual De Usuario

AT LEAST TWO PEOPLE ARE NEEDED TO PUT

THIS TABLE TOGETHER!

Figure 2

You will need the following tools to put your table

together:

o Phillips Screwdriver

o Standard (Flat Blade) Screwdriver

o Hammer or Mallet

o Pliers

o 6' or 8" Crescent Wrench

o 7/16 Wrench

o 3/8 Wrench

o 9/16 Wrench

First Table Half Assembly

1. Open the hardware kit and sort all the hardware. For

your help in identifying hardware, see the hardware

identifier on the front cover of this owner's manual.

2. Lean either table half #1 against a wall placing the two

legs #2 & #3 with hinges near the floor. (See Figure

1). Place bottom of table about 12" from wall.

IMPORTANT NOTE: If floor is not carpeted, be sure

to place a heavy object at the base of the table half

to help prevent table half from sliding away from wall.

3. Pull legs #2 & #3 out from table and lock their hinges

by pulling hinges upward as shown in figure 1, detail.

4. Put caps #13 on ends of both legs #2 & #3. (See Figure

5. Rotate U-support #7 until you see the screw hole in the

slot of U-clip #6 (See Figure 1, Detail). Slide U-support

#7 side to side if necessary.

6. Insert screw #19 through slot in U-clip #6 and into U-

support #7. Thread it all the way into U-support #7 until

it touches the back of the tube. There should be about

3/8 inch of screw #19 left sticking out. (See Figure 1)

7. Attach linkages #4 to INSIDE of legs #2 & #3. Secure

with screws #26, spacers #38, locknuts #15 and

thread protectors #23. (See Figure 2) Tighten

hardware snug to keep table stable but do not

overtighten. Tubes must pivot.

8. Attach free end of linkages #4 to OUTSIDE of U-support

#7 with screws #14 and spacers #38. Then slide

braces #9 onto the same screws #14 on INSIDE of U-

support #7. Secure with locknuts #15. (See Figure 2)

Tighten snug but do not overtighten. Tubes must

pivot.

Figure 1