Escalade Sports 2l-6433-00 Manual De Usuario
Second Table Half Assembly
9. Put tube plugs #22 into both U-braces #5. (See Figure
3).
10. Gently tap caster sockets #12 into ends of U-supports
#7 until flange on sockets touch the edge of the tube.
DO NOT USE FORCE OR A HAMMER! (See Figure 4).
11. Insert one caster #11 into each caster socket #12.
12. Attach U-brace #5 to U-supports #7. (See Figure 4)
Secure with hex bolts #18 and locknuts #16. Tighten
nuts but be careful not to crush tubes.
13. Lean second table half #1 against a wall placing the
two legs #2 & #3 with hinges near the floor. (See
Figure 5). Place bottom of table about 12" from wall.
REMEMBER: If floor is not carpeted, be sure to
place a heavy object at the base of the table half to
help prevent table half from sliding away from wall.
14. Pull legs #2 & #3 out from table and lock their hinges
by pulling hinges upward. (See detail in Figure 1,
previous page).
15. Put caps #13 on its ends of both legs #2 & #3. (See
Figure 5)
16. Rotate U-support #7 until you see the screw hole in
the slot of U-clip #6 (See Figure 5, Detail). Slide U-
support #7 side to side if necessary.
17. Insert screw #19 through slot in U-clip #6 and into U-
support #7. Thread it all the way into U-support #7
until it touches the back of the tube. There should be
about 3/8 inch of screw #19 left sticking out. (See
Figure 5, Detail).
First Table Half Assembly
(Continued)
3
Figure 5
Figure 4
Figure 3