Sun Microsystems timberwolf 9740 Manual De Usuario

95693

Revision P

A-11

  

Applying Labels

The DLTtape VOLSER letter located next to the last number in the VOLSER reflects 
the media. Cleaning cartridges have CLN in the VOLSER, diagnostic cartridges have DG 
in the VOLSER. 

See 

 and insert the label into the recessed area on each cartridge:

1. Make sure that the cartridge has been at room temperature for at least 24 hours. 

2. Clean the surface where the labels will be placed using a cleaning solution made for 

this purpose. See 

. 

3. Locate the label that you need:

•

DLTtape III has a “C” next to the far left number, bar code down. 

•

DLTtape IIIXT has an “E” next to the far left number, bar code down.

•

DLTtape IV has a “D” next to the far left number, bar code down. 

•

Diagnostic cartridge has “DG” at the beginning of the VOLSER. 

•

Cleaning cartridge has “CLN” at the beginning of the VOLSER. 

4. Hold the cartridge so that the write-protect switch is toward you. 

5. See 

 and slide the label under the slots in the recessed area. If desired, 

peel the backing from the label and then slide it under the slots. Press it into place. 

Figure A-12. DLT Cartridge Label Locations  (C62381) 

C62381

VOLSER
LABEL