Autostart as-1484ihf Manual De Usuario

User Guide 

P. 3 

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to 

become energized while running under remote start. When leaving the vehicle you must 

ensure that the windshield wiper and headlight switches are 

. Leaving the headlight switch 

 on certain types of vehicles could cause them to remain 

 even after the remote starter 

shuts down, resulting in a dead battery. 

Arming the Starter Kill 
If installed, the Starter Kill can be programmed to arm in Active Mode (will not arm 

automatically) or in Passive Mode (will arm automatically). 
•  To disarm the Starter Kill in Active or Passive Mode, press the 

 button on the trans-

mitter. The parking lights will flash twice. (If Remote Door Locks were installed, this will 

also unlock the doors.)  In Passive Mode, the system will automatically rearm 1 or 3 

minutes after the doors were unlocked. 

•  To arm the Starter Kill in Active or Passive Mode, press and hold the 

 button on the 

transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this 

will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes 

after the engine is shut down. 

Remote-starting Your Vehicle 
Setting the system to Ready Mode 

This unit is designed for Manual Transmissions only.  In order to remote-start the vehicle, the 

Unit must first be set to Ready mode.  If the Unit is not set to Ready Mode, it cannot remote-

start the vehicle.  Once the system has been set to Ready Mode, the vehicle can be remote 

started and stopped at will (as long as the Unit never exits Ready Mode). 

1. 

Ensure that all the Doors are closed and that the Gear Lever is in the Neutral 

position. 

2. 

With the Engine already running, apply the Parking Brake. 

3. 

Within 20 sec. press

 

LOCK, UNLOCK 

or

 

 on the Transmitter.

 

4. 

Remove the key: the Engine will go on running. 

5. 

Exit the vehicle and close the Door. 

6. 

Press either: 

a. 

LOCK 

to lock the Doors, arm the Alarm and shut down the Engine; 

b. 

 to unlock the Doors and shut down the Engine; 

c. 

START/STOP 

to shut down the Engine without affecting the Doors or;

 

d. 

to lock all Doors and engage idle mode.

 

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, if 

any one of the following events occurs, the vehicle will exit Ready Mode – thus eliminating 

the remote start option until Ready Mode is restored: 

•  Door opened; 

•  Hood opened; 

•  Brakes pressed; 

•  Parking Brake disengaged; 

•  Key turned to the 

 position. 

Should any of the above occur, Ready Mode will be cancelled. 
Note: The unit will notify the user that it has exited Ready Mode by giving three slow flashes 

of the vehicle’s Parking Lights.