Lowrance electronic 5300c Manual De Usuario
139
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-15
Fluid Level Sensor's settings to factory defaults. If, for example, you
execute the Restore Defaults command from your Gray Water Fluid
Level Advanced Options menu, only the settings for the Gray Water
Fluid Level will be reset to factory defaults. Other fluid levels on the
network will not be affected.
To restore default settings:
1. Press
MENU| MENU
, use
↑ ↓ to select
NMEA
2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired fluid level and press
3. Select the desired fluid level and press
ENT
. The Device Configura-
tion menu will appear.
4. Highlight
4. Highlight
A
DVANCED
O
PTIONS
and press
ENT
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
NOTE:
NOTE:
The Fluid Level Device Configuration menu also contains the Cali-
brate button, but we will address that later in the segment covering
Calibration.
Suzuki Engine Interface Configuration
To input Device Name:
1. Press
MENU| MENU
, use
↑ ↓ to select
NMEA
2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use
3. Use
↑ ↓ to select the engine interface you want to rename and press
ENT
. The Device Configuration menu will appear with the Device Name
dialog box highlighted.
www.Busse-Yachtshop.de email: info@busse-yachtshop.de