Gianni Industries DG-30 Manual De Usuario

3. The indicator signal chart:

Sound and LED indicator:

Red LED

Power on

Green LED

Relay activated

Tri-color-

Yellow

Entering the Program mode

Tri-color-

Red

Slot position is registered

LED signal

Tri-color-

Green

Slot position is ready to register

1 Beep

Slot position is ready to register、 Effective card（ PIN
codes）、Exit from the Program mode

2 Beeps

Entering the Program mode

3 Beeps

Slot position is registered 、Data computing error 、 other
operation mistakes、 duplicate card

Sound signal

5 Beeps

Master Code reset to Factory （12345）

Factory Parameter list：

Format 26 bits

Card register None

Master Codes 12345 (5 digits)

Strike Time 1 seconds

Pressed key delay time (Time Out) 5 seconds

Program mode delay time 60 seconds

Invalid PIN Lock-out time 60 seconds

4. Operation Instruction:

Enter Program Mode:

1. Compose twice the master code (Factory master is 「12345」)

→ 2 beeps and the Yellow LED will light up
→ you are now in the "programming mode".

Note:

After 60 seconds if you have not entered any codes or data, the system will

automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.

Exiting from the program mode:

1. Press「#」 to exit from the programming mode.
2.

Note:

After 60 seconds if you have not entered any codes or data, the system will

automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.

Selecting The User Format

Enter the Programming mode, Press

「＊30」

Followed

By「01」：This will set the system to be used as :Wiegand 26-bit；Slots

001~100 for cards/tokens and slots 01~150 for PIN codes

Followed

「

02」：This will set the system to be used as : Wiegand 34-bit, Slots

001~100 for cards/tokens and slots 01~150 for PIN codes