Справочник Пользователя для Gianni Industries DG-30
Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG30 Ver. A Publish:2004.08.26 Page: 2/ 4
P-MU-DG30 Ver. A Publish:2004.08.26 Page: 2/ 4
3. The indicator signal chart:
Sound and LED indicator:
Red LED
Power on
Green LED
Relay activated
Tri-color-
Yellow
Entering the Program mode
Tri-color-
Red
Slot position is registered
LED signal
Tri-color-
Green
Slot position is ready to register
1 Beep
Slot position is ready to register、 Effective card( PIN
codes)、Exit from the Program mode
codes)、Exit from the Program mode
2 Beeps
Entering the Program mode
3 Beeps
Slot position is registered 、Data computing error 、 other
operation mistakes、 duplicate card
operation mistakes、 duplicate card
Sound signal
5 Beeps
Master Code reset to Factory (12345)
Factory Parameter list:
Format 26 bits
Card register None
Master Codes 12345 (5 digits)
Strike Time 1 seconds
Pressed key delay time (Time Out) 5 seconds
Program mode delay time 60 seconds
Invalid PIN Lock-out time 60 seconds
4. Operation Instruction:
Enter Program Mode:
1. Compose twice the master code (Factory master is 「12345」)
→ 2 beeps and the Yellow LED will light up
→ you are now in the "programming mode".
→ you are now in the "programming mode".
2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
code the lockout facility will operate.
Exiting from the program mode:
1. Press「#」 to exit from the programming mode.
2.
2.
Note:
After 60 seconds if you have not entered any codes or data, the system will
automatically exit from the programming mode. After 6 wrong attempts at the master
code the lockout facility will operate.
code the lockout facility will operate.
Selecting The User Format
Enter the Programming mode, Press
「*30」
Followed
By「01」:This will set the system to be used as :Wiegand 26-bit;Slots
001~100 for cards/tokens and slots 01~150 for PIN codes
OR
Followed
By
「
02」:This will set the system to be used as : Wiegand 34-bit, Slots
001~100 for cards/tokens and slots 01~150 for PIN codes
OR