Cisco Systems 4027669 Manual De Usuario

16 

 

4028103 Rev A 

 

 

  

WARNING: 
To avoid personal injury or damage to your equipment, follow these steps in 

the exact order shown. 

1  Power off your PC and unplug it from the power source. 
2  Connect your PC to either the ETHERNET port or the USB port using the 

appropriate data cable. Do not connect your PC to both the Ethernet and USB 
ports at the same time. You can connect two separate PCs to the cable modem at 
the same time by connecting one PC to the Ethernet port and one PC to the USB 
port. 

3  Connect the active RF coaxial cable to the CABLE connector. Use an optional 

cable signal splitter to add a TV, a DHCT or set-top converter, or a VCR. 

4  Insert the AC power cord into the POWER connector on the back of the cable 

modem, and then plug the cord into an AC power source. 

5  Plug in and power on your networked devices including your PC. The cable 

modem will then begin an automatic search to locate and sign on to the 
broadband data network. This process may take up to 5 minutes. The modem 
will be ready for use when the ONLINE LED status indicator on the front panel 
stops blinking and illuminates continuously. 

6  The next step in setting up your cable modem is to configure your Internet 

devices for Internet access. Choose one of the following options: 

„ 

If you want to use Ethernet connections, you must configure the TCP/IP 
protocol. To configure the TCP/IP protocol, go to How Do I Configure 
TCP/IP Protocol? (on page 17). 

„ 

If you want to use USB connections, you must install the USB drivers. To 
install the USB Drivers for USB, go to How Do I Install USB Drivers? (on 
page 20).