U-Line CLRCO2075 Manual De Usuario

www.U-LineService.com

02/2005

™

5. Remove the top handle and discard. (This handle will be 

replaced with the Modified Handle included in the Full 
Overlay Door Panel Kit.)

6. Remove the two screws located on both sides of the 

lower handle. Remove the handle.

7. Attach the Modified Handle to the lower handle using 

the three screws removed in Step 4. Set aside.

8. Slide the existing door panel out of the doorframe.

1. Tap nylon inserts into the top holes drilled in the 

overlay panel. Use two #6 screws to attach top pivot 
bracket to the overlay panel (see Figure 19).

2. Place and tape the existing door panel on the back of 

the overlay panel (see Figure 20) and drill holes 
through both panels according to Figure 21. Remove 
tape adjoining the panels and enlarge the seven holes 
in the overlay panel using a 0.201" (#7) drill.

3. If a user-supplied cabinet handle will be used, attach its 

hardware to the overlay panel at this time.

 

4. Attach the door panel to the overlay panel using #10 x 

5/8" wood screws and nylon spacers. The nylon spacers 
fit between the overlay panel and the door panel as 
shown in Figure 22. The spacers allow the original 
door panel to slide back into the 1/4"-thick door 
reveal (channel).

Typical Wood

Panel

Top Pivot

Plate

#6 X 5/8"

Flat Head Screw

Two Required

8 mm Plug Insert

Two Required

Removed

Door Panel

Bottom of

Wood Panel

Back of

Wood

Panel

Side of

Wood Panel

Tape

5/16"

Bottom

3/8"

Both Sides

Drill 5/32" x 3/8" Deep
for usewith #10 x 5/8"
Wood Screw and Nylon
Spacer – 7 Places

1"

±

1/8"

1"

±

1/32"

1"

±

1/32"

11-7/8"

14-5/16"

±

1/4"

27"

±

1/4"

Rear View

of

Wood Panel