U-Line CLRCO2075 Manual De Usuario
02/2005
13
www.U-LineService.com
™
CLRCO2075 — Clear Ice Maker/Refrigerator
CAUTION
Plumbing installation must observe all state and local
codes. All water and drain connections MUST BE made by
a licensed/qualified plumbing contractor. Failure to follow
recommendations and instructions may result in damage
and/or harm.
codes. All water and drain connections MUST BE made by
a licensed/qualified plumbing contractor. Failure to follow
recommendations and instructions may result in damage
and/or harm.
Drain Connection
IMPORTANT
Drain can NOT be located directly below unit. Unit has a
solid base that will not allow unit to drain below itself.
solid base that will not allow unit to drain below itself.
The CLRCO2075 can be installed using a Gravity Drain, a
Factory-Installed Drain Pump (U-Line P60) or a Locally-
Installed Drain Pump. Drain lines must have a 5/8-inch
inside diameter. The floor drain must be large enough to
accommodate drainage from all attached drains.
Factory-Installed Drain Pump (U-Line P60) or a Locally-
Installed Drain Pump. Drain lines must have a 5/8-inch
inside diameter. The floor drain must be large enough to
accommodate drainage from all attached drains.
Follow these guidelines when installing drain lines to
prevent water from flowing back into the ice maker
storage bin and/or potentially flowing onto the floor,
causing water damage:
prevent water from flowing back into the ice maker
storage bin and/or potentially flowing onto the floor,
causing water damage:
Gravity Drain
A Gravity Drain may be used if:
• Drain line has at least a 1-inch drop per 48 inches of
run (1/4 inch per foot).
• Drain line does not create traps or created traps are
vented (see Figure 30).
See Figure 31 for a typical Gravity Drain installation.
If using a Gravity Drain:
1. Attach the 5/8-inch ID drain connection on the back of
the unit to a 5/8-inch OD rigid tube, using a worm
clamp.
clamp.
2. Attach the other end of the rigid tube to your 5/8-inch
ID drain line with a worm clamp.
3. Insulate the drain line, if necessary to prevent
condensation. Go on to Water Supply Connection.
Factory-Installed Drain Pump
If your drain line will run up to a stand pipe, disposal
assembly or spigot assembly or does not otherwise meet
the requirements for a Gravity Drain, you may have
ordered the CLRCO2075 with a U-Line P60 Drain Pump.
See Figures 32, 33 and 34 for typical installations
requiring a Drain Pump. If you need to install a P60 Drain
Pump into your unit, see Locally-Installed Drain Pump on
Page 15.
assembly or spigot assembly or does not otherwise meet
the requirements for a Gravity Drain, you may have
ordered the CLRCO2075 with a U-Line P60 Drain Pump.
See Figures 32, 33 and 34 for typical installations
requiring a Drain Pump. If you need to install a P60 Drain
Pump into your unit, see Locally-Installed Drain Pump on
Page 15.
6 Prepare Plumbing
Normal
Proper Drain
With Trap
Poor Drainage, Water Will Back Up
With Trap and Vent
Proper Drain
Figure 30
Waste
Waste
Cold
Water
Shut-Off
Valve
Hot
Water
Figure 31
Gravity Drain
Cold
Water
Hot
Water
Waste
Waste
Shut-Off
Valve
Figure 32
Stand Pipe