Hoshizaki FD-1001MRH(-C) Manual De Usuario
3
b) Infrared Sensor Shutdown Delay (S1 dip switch 1, 2, & 3)
Infrared sensor shutdown delay is the delay between the infrared sensor detecting ice
(yellow LED flashing or steady) and the start of the shutdown sequence. For dispenser
unit applications, the ice level at shutoff may need to be adjusted depending on the
dispenser agitation or dispense method. Increasing the shutdown delay setting allows for
a higher level of ice in the bin before the icemaker shuts down. For a typical dispenser
unit application, a 100-second shutdown delay is recommended. When used with a
standard Hoshizaki storage bin, any shutdown delay setting is acceptable.
(yellow LED flashing or steady) and the start of the shutdown sequence. For dispenser
unit applications, the ice level at shutoff may need to be adjusted depending on the
dispenser agitation or dispense method. Increasing the shutdown delay setting allows for
a higher level of ice in the bin before the icemaker shuts down. For a typical dispenser
unit application, a 100-second shutdown delay is recommended. When used with a
standard Hoshizaki storage bin, any shutdown delay setting is acceptable.
WARNING
Increasing the shutdown delay allows a higher level of ice in the dispensing
unit/storage bin before shutdown. This could lead to icemaker movement or ice
overflow.
unit/storage bin before shutdown. This could lead to icemaker movement or ice
overflow.
S1 Dip Switch Setting
Infrared Sensor Shutdown Delay
No. 1
No. 2
No. 3
OFF
OFF
OFF
0 Seconds
ON
OFF
OFF
100 Seconds (1.6 minutes) (Factory Default)
OFF
ON
OFF
1100 Seconds (18.3 minutes)
OFF
OFF
ON
1650 Seconds (7.5 minutes)
ON
ON
OFF
00 Seconds (36.7 minutes)
OFF
ON
ON
0 Seconds
ON
ON
ON
0 Seconds
c) Drain Frequency Control (S1 dip switch 4)
This unit is factory set for optimum performance with the 1-in-1 drain cycle (S1 dip
switch 4 in the "OFF" position). This setting allows for removal of sediment from the
evaporator without interrupting the icemaking process. An optional 1-in-1 drain cycle is
available.
switch 4 in the "OFF" position). This setting allows for removal of sediment from the
evaporator without interrupting the icemaking process. An optional 1-in-1 drain cycle is
available.
S1 Dip Switch Setting
Drain Timer Interval Drain Valve Open
No. 4
OFF (1-in-1)
1 Hour
Seconds
ON (1-in-1)
11 Hours 45 Minutes
10 Minutes
d) Continuous Dispensing Timer (S1 dip switch 5 & 6)
DCM models only. The dispense mode switch on DCMs must be in the "CONTINUOUS"
position for this setting to apply. The factory setting allows ice to be dispensed
continuously as long as the dispense solenoid is activated.
position for this setting to apply. The factory setting allows ice to be dispensed
continuously as long as the dispense solenoid is activated.
S1 Dip Switch Setting
Dispense Time
No. 5
No. 6
OFF
OFF
No Limit
ON
OFF
0 Seconds
OFF
ON
60 Seconds
ON
ON
No Limit