Zebra Technologies R110Xi Manual De Usuario
132
R110Xi/R170Xi User Guide
23063L-003 Rev. 1 12/6/04
Troubleshooting
Communications Problems
Communications Problems
identifies problems with communications, the possible causes, and the recommended
solutions.
Table 16 • Communications Problems
Problem
Possible Cause
Recommended Solution
A label format was sent to
the printer but was not
recognized. The DATA
light does not flash.
the printer but was not
recognized. The DATA
light does not flash.
The communication
parameters are incorrect.
parameters are incorrect.
Check the printer driver or software
communications settings (if applicable).
communications settings (if applicable).
.
Make sure you are using the correct
communication cable. See
communication cable. See
for the requirements.
Using the front panel controls, check the
protocol setting. It should be set to
protocol setting. It should be set to
NONE
. See
.
If a driver is used, check the driver
communication settings for your connection.
communication settings for your connection.
A label format was sent to
the printer. Several labels
print, then the printer
skips, misplaces, misses, or
distorts the image on the
label.
the printer. Several labels
print, then the printer
skips, misplaces, misses, or
distorts the image on the
label.
The host is set to EPP
parallel communications.
parallel communications.
.
The serial communication
settings are incorrect.
settings are incorrect.
Ensure that the flow control settings match.
Check the communication cable length. See
requirements.
Check the printer driver or software
communications settings (if applicable).
communications settings (if applicable).
A label format was sent to
the printer but was not
recognized. The DATA
light flashes but no
printing occurs.
the printer but was not
recognized. The DATA
light flashes but no
printing occurs.
The prefix and delimiter
characters set in the printer
do not match the ones in the
label format.
characters set in the printer
do not match the ones in the
label format.
Verify the prefix and delimiter characters. See
and
for the
requirements.
Incorrect data is being sent
to the printer.
to the printer.
Ensure that ZPL is being used.
Check the communication settings on the
computer. Ensure that they match the printer
settings.
computer. Ensure that they match the printer
settings.