Konica Minolta 7013 psc Manual De Usuario

TCP/IP Configuration-35

/usr/nic/lpr_print /dev/nic/printer_name printfast 

10001 & 

This example reflects names supplied to the script earlier.

When the installation script is complete, you must configure the printer and make it 
known to the lp system. The HP/UX lp system uses the lpadmin maintenance com-
mand to configure a printer (there is not a /etc/printcap file). The specific commands to 
do this are:

lpadmin -p printer_name -v /dev/nic/printer_name

enable printer_name

accept printer_name

You can also use other options for the lpadmin command. See your system documen-
tation for details. 

Note:

The printer name must be the same as the one you entered during the Print Server 

Card installation. HP supplies the sam program as an alternative to configure the 

printer.

When using sam, specify everything as if the printer were directly connected to /dev/
lprprinter/printer_name.

The software installed with your HP system can satisfy most of your printing needs. 
HP supplies ASCII-to-PostScript filters and the system will invoke them automatically 
if you define the content type of the printer as PostScript. The HP/UX lp system also 
supplies interface scripts that produce PostScript banners. Use the lpfilter command 
to define new filters and content types if necessary. The full power and flexibility of 
the lp print service is now available to you.  The fact that you are printing across the 
network is completely transparent.

Installation and setup is exactly the same for System V Solaris and SVR4 i386-based 
machines.  Solution uses a network direct filter called nicfilter. The system invokes 
nicfilter directly from the printer interface file. To load the software, create a /usr/nic 
directory and tar the TCP/IP software to it.

1. Go to the /usr/nic directory by entering the following:

cd /usr/nic

2. Run the Installation script by typing: nicinst.