Konica Minolta 7013 psc Manual De Usuario

TCP/IP Configuration-37

8. Type the following commands:

accept <printer name> and press [Enter].

enable <printer name> and press [Enter].

Note:

After each entry, lpadmin should provide an acknowledgment of the command 

invoked.

9. Type the command:

lp -d <printer name> /etc/hosts, and press [Enter].

10. Check for output, or type the following:

lpstat <printer name> or -t.

Installation and setup is similar for HP/UX and SCO UNIX systems. The Print Server 
Card solution uses a network direct filter called nicfilter. The system invokes nicfilter 
directly from the printer interface file.

After completing software download in Section 7.4.3.1 Loading the Software,  you 
must configure the printer and make it known to the lp system. Follow the steps below:

1.  Run the Installation script by typing: nicinst.

The script automatically downloads the correct Print 

Server Card utilities for your particular system and 

prompts you for information as needed.

2. Select your system. Choose one from these options:

1) AT&T/SVR4; 386

2) SCO UNIX System V

3) None of the above

Type 1, 2, or 3 and press [Enter].

3. What is the node name of the Print Server Card? 

Type the name assigned in the /etc/hosts file and press [Enter]. For example, 

printfast

4. What is the printer name for this Print Server Card-linked printer?

Type a printer name and press [Enter].