Friedrich hazardgarg r-410a Manual De Usuario

Diffuser with directional louvers used to direct the conditioned airflow.

Attaches to the indoor side of the fan motor shaft and is used for distributing unconditioned, room side air through 

the heat exchanger and delivering conditioned air into the room.

Attaches to the outdoor side of the fan motor shaft and is used to move outside air through the condenser coil, while 

slinging condensate water out of the base pan and onto the condenser coil, thus lowering the temperature and 

pressures within the coil. 

Used to maintain the specified room side comfort level.

Used to regulate the operation of the fan motor and the compressor or to turn the unit off. For troubleshooting, refer 

to the wiring diagrams and schematics in the back of this service manual.

Used to energize the compressor and fan motor. Each unit has 2, 50 amp, 208/230 volt relays.

Reduces line current and steadies the voltage supply, while greatly improving the torque characteristics of the fan 

motor and compressor motor.

Dual shafted fan motor operates the indoor blower wheel and the condenser fan blade simultaneously.

Motorized device used to compress refrigerant through the sealed system.

Used for low ambient cooling operation, the valve is connected between the discharge line at the compressor and 

the suction process tube. It responds to suction pressure, whcih when reduced in the system, causes the valve to 

open and bypass hot gas from the high pressure side to the low pressure side of the system. The valve is preset 

to open when the suction pressure reaches 50 psig.

A cylindrical meter device used to evenly distribute the flow of refrigerant to the heat exchangers (coils).

10