Cisco Systems ATA 188 Manual De Usuario
4-7
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator’s Guide (H.323)
OL-4008-01
Chapter 4 Basic and Additional H.323 Services
Additional H.323 Services
Related Configuration Parameters
•
•
Setting the Audio Codecs
You can configure the following codec-related settings:
•
Low-bit-rate codec—When operating with a low-bit-rate codec, the Cisco ATA can support either
two G.723.1 connections or one G.729 connection. You must statically configure the selection of
G.723.1 or G.729 by using the LBRCodec parameter.
two G.723.1 connections or one G.729 connection. You must statically configure the selection of
G.723.1 or G.729 by using the LBRCodec parameter.
When G.723.1 is the low-bit-rate codec, each FXS port is allocated one G.723.1 connection. When
G.729 is used, only one FXS port can use G.729. The G.729 resource is allocated in a dynamic
manner. When a call begins, the FXS port requests and takes an available G.729 resource. The
Cisco ATA releases this resource when the call is completed.
G.729 is used, only one FXS port can use G.729. The G.729 resource is allocated in a dynamic
manner. When a call begins, the FXS port requests and takes an available G.729 resource. The
Cisco ATA releases this resource when the call is completed.
Use Bit 1 of the AudioMode parameter to disable and enable the use of the low-bit-rate codec.
Related Configuration Parameters
–
–
•
Voice codec—You can configure the preferred voice codec for transmitting and receiving voice data
by using the TxCodec and RxCodec parameters, respectively. Cisco recommends that you configure
the same voice codec for TxCodec and RxCodec.
by using the TxCodec and RxCodec parameters, respectively. Cisco recommends that you configure
the same voice codec for TxCodec and RxCodec.
Related Configuration Parameters
–
–
•
Silence suppression—You can configure silence suppression for G.711/G.723.1/G.729 by using the
ConnectMode parameter (Bit 0 for the Phone 1 port and Bit 16 for the Phone 2 port).
ConnectMode parameter (Bit 0 for the Phone 1 port and Bit 16 for the Phone 2 port).
Related Configuration Parameter
Additional H.323 Services
This section describes additional H.323 services and, where applicable, provides configuration
information and cross references to the parameters for configuring these services, described in
alphabetical order:
information and cross references to the parameters for configuring these services, described in
alphabetical order:
•
•
•
•
•
•
•