Bunn CDS-3 Manual De Usuario

2

This equipment supplies a liquid mix to the  hoppers on the CDS-2 or 3 dispensers.  It is for indoor use only on 

a sturdy counter or shelf.

Bunn-O-Matic Corp. (“BUNN”) warrants equipment manufactured by it as follows:

1) All equipment other than as specified below: 2 years parts and 1 year labor.

2) Electronic circuit and/or control boards: parts and labor for 3 years.

3) Compressors on refrigeration equipment: 5 years parts and 1 year labor.

4) Grinding burrs on coffee grinding equipment to grind coffee to meet original factory screen sieve analysis: parts and 

labor for 3 years or 30,000 pounds of coffee, whichever comes first.

These warranty periods run from the date of installation BUNN warrants that the equipment manufactured by it will be 

commercially free of defects in material and workmanship existing at the time of manufacture and appearing within the 

applicable warranty period. This warranty does not apply to any equipment, component or part that was not manufactured 

by BUNN or that, in BUNN’s judgment, has been affected by misuse, neglect, alteration, improper installation or operation, 

improper maintenance or repair, damage or casualty. This warranty is conditioned on the Buyer 1) giving BUNN prompt 

notice of any claim to be made under this warranty by telephone at (217) 529-6601 or by writing to Post Office Box 3227, 

Springfield, Illinois 62708-3227; 2) if requested by BUNN, shipping the defective equipment prepaid to an authorized BUNN 

service location; and 3) receiving prior authorization from BUNN that the defective equipment is under warranty.

FOR A PARTICULAR PURPOSE. The agents, dealers or employees of BUNN are not authorized to make modifications to 

this warranty or to make additional warranties that are binding on BUNN. Accordingly, statements by such individuals, 

whether oral or written, do not constitute warranties and should not be relied upon.

If BUNN determines in its sole discretion that the equipment does not conform to the warranty, BUNN, at its exclusive 

option while the equipment is under warranty, shall either 1) provide at no charge replacement parts and/or labor (during 

the applicable parts and labor warranty periods specified above) to repair the defective components, provided that this 

repair is done by a BUNN Authorized Service Representative; or 2) shall replace the equipment or refund the purchase 

price for the equipment.

In no event shall BUNN be liable for any other damage or loss, including, but not limited to, lost profits, lost sales, loss of 

use of equipment, claims of Buyer’s customers, cost of capital, cost of down time, cost of substitute equipment, facilities 

or services, or any other special, incidental or consequential damages.

1.  Locate the hopper elbow with slide gate, whipping chamber with dispense tip, and mixing chamber located 

in the Powder Auto-Fill hopper.

2.  Assemble the hopper elbow with slide gate to the hopper.

3.  Assemble the whipping chamber with dispense tip to the whipper receptacle on the Powder Auto-Fill.

4.  Assemble the mixing chamber to the whipping chamber and water inlet on the Powder Auto-Fill.

5.  Locate the door assembly and door mounting hardware taped to the back of the door assembly.

6.  Remove the door mounting hardware from the bag and set it aside

7.  Carefully lift the door and locate the lamp cord connector. 

8.  Connect the door lamp cord connector to the receptacle located on the top of the Powder Auto-Fill.

9.  Carefully rotate the support arms on the back of the door so they are roughly perpendicular to the rear of the 

door.

29793 080102