Bunn CDS-3 Manual De Usuario

20

CONTROL BOARD and LEVEL PROBE (cont.)
Removal and Replacement:

1.  Disconnect the dispenser from the power source.

2.  Remove the two plugs (J1 and J7) from the main 

wiring harness, the potentiometer plug (J3), the 

photo transistor plug (J6), and the photo LED plug 

(J2) from the control board.

3.  Remove the four #6-32 keps nuts securing the con-

trol board to the hopper motor mounting panel.

4.  Remove the control board.

5.  Remove the four spacers from the old control board 

and install them into the new control board.

6.  Instal the new control board using the four #6-32 

keps nuts.

7.  Reconnect  the  two  plugs  (J1  and  J7)  from  the 

main wiring harness, the potentiometer plug (J3), 

the photo transistor plug (J6), and the photo LED 

plug (J2) to the control board. Refer to Fig. 12.

FIG. 12 CONTROL BOARD WIRING

P1905

29793 061599