Cisco Systems unified 9971 Manual De Usuario

This section describes steps for adding a user to Cisco Unified Communications Manager. Follow one 
of the procedures in this section, depending on your operating system and the manner in which you are 
adding the user:

If you added a user to an LDAP Directory (a non-Cisco Unified Communications Server directory), you 
can immediately synchronize that directory to the Cisco Unified Communications Manager on which 
you are adding this same user and the user’s phone by following these steps:

Log onto Cisco Unified Communications Manager Administration.

Choose System > LDAP > LDAP Directory.

Use the Find button to locate your LDAP directory.

Click on the LDAP directory name. 

Click Perform Full Sync Now.

If you do not need to immediately synchronize the LDAP Directory to the Cisco Unified 
Communications Manager, the LDAP Directory Synchronization Schedule on the LDAP 
Directory window determines when the next auto-synchronization is scheduled. However, the 
synchronization must occur before you can associate a new user to a device.

Proceed to 

If you are not using an LDAP directory, you can add a user directly to Cisco Unified Communications 
Manager Administration by following these steps:

Choose User Management > End User, then click Add New. The End User Configuration window 
appears.

In the User Information pane of this window, enter the following:

User ID—Enter the end user identification name. Cisco Unified Communications Manager does 
not permit modifying the user ID after it is created. You may use the following special 
characters: =, +, <, >, #, ;, \, , "", and blank spaces.