Cisco Systems 7000 Manual De Usuario
C H A P T E R
S e n d d o c u m e n t c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
2-1
Cisco Nexus 7000 System Site Preparation Guide
OL-15846-01
2
Preparing the Site
This chapter describes the basic site requirements that you should be aware of as you prepare to install
your Nexus 7000 Series devices.
your Nexus 7000 Series devices.
This chapter includes the following sections:
•
•
•
•
•
•
•
•
•
•
About the Nexus 7000 Series
Environmental factors can adversely affect the performance and longevity of your system. The Nexus
7000 Series devices require a dry, clean, well-ventilated, and air-conditioned environment. To ensure
normal operation, you must maintain ambient airflow. If the airflow is blocked or restricted and or if the
intake air is too warm, an overtemperature condition can occur and the environmental monitor on the
system will shut down to protect the system components.
7000 Series devices require a dry, clean, well-ventilated, and air-conditioned environment. To ensure
normal operation, you must maintain ambient airflow. If the airflow is blocked or restricted and or if the
intake air is too warm, an overtemperature condition can occur and the environmental monitor on the
system will shut down to protect the system components.
You can mount up to two chassis in a rack with little or no clearance above and below the chassis. You
must, however, have enough room in front for loading the chassis using a mechanical lift and enough
room in the rear for removing the system components. When mounting the chassis in a rack with other
equipment, ensure that the exhaust from other equipment does not blow into the air intake vent of the
chassis. If your site has warm and cold aisles, align the rack or cabinet air intake to a cold aisle and
exhaust to a warm aisle.
must, however, have enough room in front for loading the chassis using a mechanical lift and enough
room in the rear for removing the system components. When mounting the chassis in a rack with other
equipment, ensure that the exhaust from other equipment does not blow into the air intake vent of the
chassis. If your site has warm and cold aisles, align the rack or cabinet air intake to a cold aisle and
exhaust to a warm aisle.