bobcat t190 Manual De Usuario

Check the engine oil level every day before starting the
engine for the work shift.

Park the machine on level ground. Open the rear door
and remove the dipstick (1) [Figure 152].

Keep the oil level between the marks on the dipstick. Do
not overfill.

Use good quality motor oil that meets API Service
Classification of CD or better.

Install the dipstick and close the rear door.

For the service interval for replacing the engine oil and
filter. (See SERVICE SCHEDULE on Page 67.)

Run the engine until it is at operating temperature. Stop
the engine.

Open the rear door and remove the drain hose from its
storage position (2) [Figure 152].

Remove the drain plug (3) [Figure 152] and drain the oil
into a container and recycle or dispose of used oil in an
environmentally safe manner.

Remove the oil filter (4) [Figure 152] and clean the filter
housing surface.

Put oil on the new filter gasket, install the filter and hand
tighten.

Install and tighten the drain plug.

Remove the fill cap (5) [Figure 152].

Put oil in the engine. For the correct quantity (See Fluid
Capacities on Page 124). Do not overfill.

Start the engine and let it run for several minutes. Stop
the engine and check for leaks at the filter.

Remove the dipstick (1) [Figure 152] and check the oil
level.

Add oil as needed if it is not at the top mark on the
dipstick.

Install the dipstick and close the rear door.

P-48472

P-48473

P-48473

P-24679