caddx nx-4 Manual

9

When you enter the protected area through one of the designated Entry/Exit
doors, the keypad control will sound a continuous tone for the duration of the
entry delay time, or until you enter a valid code.  The red 

armed light

 will go off

and the tone will stop. The security system is now DISARMED.  If a valid code is
not entered before the end of the entry delay, an alarm will occur.  (NOTE:  If the
red 

been activated in your absence. Leave the building immediately and call
your alarm company and/or the police from a safe location.)

CANCEL / ABORT FEATURE  (Optional, see page 1)

The 

cancel light

 will flash during an abort delay time.  If a code is entered

followed by the [CANCEL] key while this light is flashing, all abortable reports will
stop the communication process. Entering a code followed by the [CANCEL] key
during or after an alarm report to the central station will cause the 

cancel light

 to

come on. It will stay on until the central station has received the cancel report.

If you wish to bypass one or more zones, this must be done while the system is in
the disarmed state. The following steps are used for bypassing zones:

Step 1

Press the [BYPASS] key.

Step 2

Enter user code, if required (optional).  The 

bypass light

 flashes.

Step 3

Enter the 1-digit number for the zone you wish to bypass. (Example:
Press the [1] key for zone 1, press [4] for zone 4.)

Step 4

Press the [BYPASS] key again.

Step 5

The  corresponding 

zone light

 will illuminate indicating the zone has

been bypassed.  Repeat steps 3 and 4 for any other zone(s) that
need to be bypassed.

Step 6

Press  the  [BYPASS] key again  -or- press the [#] key to exit the
Bypass Mode. The 

bypass light

 will stop flashing upon exiting the

Bypass Mode.

By pressing the [BYPASS] key, followed by the [0] key, then the [BYPASS] key
again, all zones that are designated as group bypass zones will be bypassed.
Press the [BYPASS] key again to exit group bypassing.