cat-eye ec5000e Manual De Usuario

Problem

Item to check

Countermeasure

Problems noted in the following chart are not disorders. Prior to seeking repair, read the contents of the entire chart first.

Turn the power on.

Display does not appear.

Is the power supply connected?

Connect the AC adaptor correctly. (see

page 10)

Is the power switch on?

Isn't the cable of the AC Adapter dam-
aged?

Replace the AC Adapter if its interior
circuit or the cable is damaged.

For longer use of the Ergociser™ EC-5000, observe the following precautions.
• Do not disassemble the main and control units. In case of problems contact your dealer where the unit was purchased.
• Avoid using the Ergociser™ EC-5000 in a high temperatures or in high humidity. Also, do not splash the unit with water.
• Handle the pulse sensor carefully. If strongly pulled out the cable may become disconnected.
• When the EC-5000 is not in use, shut the power switch OFF and disconnect the power cord from the outlet.
• Do not wipe the main unit with organic solvents such as thinner, kerosine, gasoline and alcohol. When dirty, wipe the unit

with a cloth soaked in a neutral detergent, then wipe well with a dry cloth.

• Do not place the EC-5000 in direct sun light.

“CARD ERROR” or irregular display
appears when you insert the data card.

Isn't the data card reversed?

Hold the card perple arrow side up, and
insert to the direction of arrow.

Didn't you insert the card too quickly?

Insert the card slowly.

Didn't you specify two or more pro-
grams, or open unnecessary holes?

Refer to P.32~33 and specify the pro-
gram and conditions correctly.

The pulse rate is not displayed, remain-
ing "0".

Is the pulse sensor attached correctly to
your earlobe?

Attach the pulse(earlobe) sensor at the
correct position, and keep the sensor
and the cable from swinging excessively.

Is the sensor plug completely inserted
into the sensor jack?

Insert the sensor plug securely into the
sensor jack, and check the pulse sensor
function according to page 11. If the sen-
sor cable proves to be broken, replace
the pulse sensor  (part #7801300).

Isn't the sensor cable damaged?

Is the select switch set correctly?

Refer to page 7 to confirm the setting of
the select switch at the back of the con-
trol unit.

The scale unit for pedal speed, elevation
or weight is not correct.

Hasn't the the upper pulse limit alarm
been activated due to the excess of your
pulse rate?

Input your age correctly to prevent the
alarm from being unduly activated.

The program is suspended halfway.

Is your age correctly registered, for an
appropriate upper pulse limit?

The pulse rate increases abnormally.

• Cat Eye Co., Ltd. guarantees that the Cateye Ergociser™  Model EC-5000 is

free from material defects and malfunctions under correct and normal use for
three (3) years from the date of purchase.  In case there should be defects or
malfunctions, Cat Eye will repair or replace the unit or parts, according to the
terms and conditions mentioned in the separate Warranty Card.

• If repair service is required, contact your dealer where the unit was purchased.
• The warranty covers only the main unit and the control unit. Accessories such

as the pulse sensor or the AC adaptor are not covered.

Data Card (10 pcs)
(Part #7816120)

Wireless Chestbelt Pulse Sensor Kit
(Part#7016701)

Wireless Pulse Rate Receiver Kit
(Part#7016801)

Pulse Sensor
(Part #7801300)