jetway 917gbar3a Manual De Usuario

Descargar
Página de 54
 
 
 
                                                                                                                                                                                                                                                                                                                                                
 
 
 
 
40 
3-9  PnP/PCI Configuration Setup 
This section describes configuring the PCI bus system. PCI, or Personal  Computer 
Interconnect, is a system which allows I/O devices to operate at speeds nearing the speed the 
CPU itself uses when communicating with its own special components. This section covers 
some very technical items and it is strongly recommended that only experienced users should 
make any changes to the default settings. 
Phoenix – AwardBIOS CMOS Setup Utility  
PnP/PCI Configurations 
 
Item Help 
   Reset Configuration Data        Disabled 
   Resources Controlled By         Manual 
 x IRQ Resources                   Press Enter 
   PCI/VGA Palette Snoop           Disabled 
   ** PCI Express relative items** 
   Maximum Payload Size            4069 
 
 
 
 
 
 
 
 
  Menu Level > 
 
↑↓→←
 Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit  F1:General Help 
F5:Previous Values    F6:Optimized Defaults   F7:Standard Defaults 
Reset Configuration Data 
Normally, you leave this field Disabled. Select Enabled to reset Extended System Configuration 
Data (ESCD) when you exit Setup if you have installed a new add-on and the system 
reconfiguration has caused such a serious conflict that the operating system can not boot.  The 
settings are: Enabled and Disabled. 
Resource Controlled By 
The Award Plug and Play BIOS has the capacity to automatically configure all of the boot and 
Plug and Play compatible devices.  However, this capability means absolutely nothing unless 
you are using a Plug and Play operating system such as Windows
95/98.  If you set this field 
to “manual” choose specific resources by going into each of the sub menu that follows this 
field (a sub menu is preceded by a “>”). 
The settings are: Auto(ESCD), Manual. 
IRQ Resources 
When resources are controlled manually, assign each system interrupt a type, depending on 
the type of device using the interrupt. 
Please refer to section 3-9-1 
PCI/VGA Palette Snoop 
Leave this field at Disabled.  The settings are Enabled, Disabled.