Panasonic ICX Manual
ICX-40-200
ICX (International) issued December 1999
25
Section 200 - General Description
Chapter 2 - System Hardware
DID Trunk Card - DID (VB-44520) (HK only)
This card supports 8 DID incoming CO lines using Immediate and Wink signaling methods. The DID
can be either Dial Pulse (10PPS) or DTMF (only for Wink). MFR circuits are used when the Wink
method is selected.
can be either Dial Pulse (10PPS) or DTMF (only for Wink). MFR circuits are used when the Wink
method is selected.
An internal -48V Power Supply (VB-44022) must be installed in the same cabinet with the E&M Trunk
Card.
Card.
A lightning arrester is built into the DID TRK card.
EXTENSION CARDS
Digital Extension Card - DEC (VB-44610)
This card provides 8 digital circuits. Each circuit supports the Panasonic Digital Key Telephone,
Digital Single Line Telephone, DSS/72, and EM/24. Supply voltage for the telephones is supplied by
the digital circuits.
Digital Single Line Telephone, DSS/72, and EM/24. Supply voltage for the telephones is supplied by
the digital circuits.
This card can be installed in any flexible slot.
Analog Extension Unit (VB-44520)
This card provides 8 analog circuits. Each circuit supports standard analog telephone devices such as
analog telephones, answering machines, fax machines, modems, cordless telephones, etc. The
connected device(s) can be either pulse dial (rotary) or DTMF. Ringer circuitry is built into the card.
analog telephones, answering machines, fax machines, modems, cordless telephones, etc. The
connected device(s) can be either pulse dial (rotary) or DTMF. Ringer circuitry is built into the card.
A lightning arrester is built into the analog circuits.
BRI Unit (S-point) (VB-44630)
This unit supports Basic Rate Interface (2B+D:144 or 192kbps) for S-point ISDN. Each card provides
4 BRI circuits.
4 BRI circuits.
This card can be installed in any flexible slot.
The system supplies +40V to the ISDN terminal which is connected to S-point interface card.
A lightning arrester is built into the BRI circuits.
Primary Rate Interface Card (S-point)-PRI (VB-44540)
Same card as T-point.
One-Line SLT Card (VB-43702UK/HK)
Analog Single Line device can be connected to DEC card through this interface card.
OPTIONS
MFR Card (VB-44110)
The Multi-Frequency Receiver (MFR) card accepts dialled DTMF tones and determines the dialled
digits. Each card contains 8 receiver circuits.
digits. Each card contains 8 receiver circuits.
This card can be installed in either an option slot or any flexible slot. A maximum of one card can be
installed in a cabinet, with up to 6 cards in a fully configured system.
installed in a cabinet, with up to 6 cards in a fully configured system.