CXtec NEW COMPATIBLE CWDM 1530 NM SINGLE MODE SFP WITH LIFETIME WARRANTY Guia De Especificaciones
8
Cisco CWDM GBIC and CWDM SFP Installation Note
78-15222-02
Connecting to the CWDM Passive Optical System
Removing a CWDM SFP Module
To remove a CWDM SFP module, use
as a reference and follow these steps:
Step 1
Disconnect the fiber-optic connector cable from the CWDM SFP module.
Step 2
Pivot the bale out and down to eject the CWDM SFP module. If the bale-clasp latch is obstructed and
you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
you cannot use your index finger to open it, use a small, flat-blade screwdriver or other long, narrow
instrument to open the bale-clasp latch.
Step 3
Grasp the CWDM SFP between your thumb and index finger and, carefully slide the module out of the
receptacle.
receptacle.
Step 4
Close the CWDM SFP bale-clasp and then insert the dust plug into the optical bores. Place the CWDM
SFP in an antistatic bag or other protective environment.
SFP in an antistatic bag or other protective environment.
Figure 6
Removing a CWDM SFP Module
Connecting to the CWDM Passive Optical System
For information on connecting your CWDM GBICs and CWDM SFP modules to a CWDM network,
refer to the Installation Note for the Cisco CWDM Passive Optical System.
refer to the Installation Note for the Cisco CWDM Passive Optical System.
94127