Brandmotion FDMC-1220 Manual De Propietario
1220 Instructions 6-26-14.docx
Page 4 of 5
Step 13: Route black connector of Charging
Module through 1/2" hole and place module
in bin. Flip tray over and insert the (4) 3/8”
Pan Head T-15 Torx Screws through tray into
module.
Module through 1/2" hole and place module
in bin. Flip tray over and insert the (4) 3/8”
Pan Head T-15 Torx Screws through tray into
module.
Step 14: Install Non-Slip Freedom Charge
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Mat to Wireless Charging Module. Place the 4
locator pins in corresponding holes.
Step 15: Firmly press Mat around LED.
Step 16: Attach Ground Eyelet of Power
harness to upper 13mm Bolt on drivers foot
well metal console bracket.
harness to upper 13mm Bolt on drivers foot
well metal console bracket.
Step 17: Pull down driver side knee bolster
trim to reveal interior air sensor plug.
trim to reveal interior air sensor plug.
Step 18: Splice Red wire of Power Harness to
the Blue (12v ignition) wire of the interior
sensor plug.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing
the Blue (12v ignition) wire of the interior
sensor plug.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing