Brandmotion FDMC-1280 Manual De Propietario
1280Instructions1-22-15.doc Page
3
of
3
Step 6: Insert connector of FreedomCharge
module through the 1/2" drill hole and firmly
press down.
module through the 1/2" drill hole and firmly
press down.
Step 8: Splice wire of Power Harness to the
12v Switched Ignition
wire of the power
point plug and the Ground wire to Black wire
of Power Harness.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
of Power Harness.
RECOMMENDED: Solder wires and cover with Heat
Shrink Tubing.
Step 9: Connect Power Harness to Charging
Module.
Module.
Step 10: Test system. LED light will
illuminate Blue once accessories are on.
Once Qi equipped device is placed on
Freedom Charge LED will illuminate Green
and charging begins. *Please note on some
devices syncing may take up to 15 seconds. Coil
locations vary on various devices; move device on
mat until LED illuminates green.
illuminate Blue once accessories are on.
Once Qi equipped device is placed on
Freedom Charge LED will illuminate Green
and charging begins. *Please note on some
devices syncing may take up to 15 seconds. Coil
locations vary on various devices; move device on
mat until LED illuminates green.
Step 11: Reassemble vehicle. Follow your
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
disassembly steps in reverse order, taking care not
to bind the harness wiring when reinstalling trim.
Step 12: Place removable consumer product
label on center of mat.
label on center of mat.